Usually, before the poultry feed processing equipment leaves the factory, it has been inspected and checked many times. The motor has been sealed with lead, and the coupling has been calibrated. Please do not loosen it. During the period of use, the staff need to regularly clean the iron impurities on the permanent magnet cylinder and the permanent magnet plate of the feeder. At the same time, during the operation of the equipment, it is also necessary to carefully check whether the fineness of the crushed raw materials meets the production requirements.

At the same time, pay attention to observe the operation status of poultry feed processing equipment. In particular, after using for a period of time, the dust collector bag should be cleaned or replaced regularly (to ensure that the bag is breathable), and the working condition of the solenoid valve should be checked regularly (to see if it can normal work). In addition, the wear of each wearing part should be checked regularly and replaced in time if necessary.

Also pay attention to vibrations in poultry feed pellet mill. If it is found that the hammers are seriously worn and need to be replaced, you should pay attention to weighing to ensure that the weight difference between the two opposite hammers on the two opposite (1800 direction) hammer pin shafts is ≤ 1g and the two opposite (1800 direction) hammer pins The total weight difference of the hammers on the shaft is ≤2g. If it is found that the screen is seriously worn and needs to be replaced, pay attention to the flatness of the new screen and whether the size of the screen is reasonable, and whether the installation is in place. When installing, make the screen wool face inward.

In addition, if the poultry feed processing equipment suddenly has abnormal conditions such as high vibration and high noise, it needs to be stopped immediately for inspection. During daily use, it is also necessary to do a good job of lubricating care. If it is found that the output of poultry feed processing equipment suddenly drops, in addition to the factors of raw materials, it is necessary to check whether the air supply door is in place, whether the pipeline is leaking, whether the pulse cloth bag is blocked, whether the solenoid valve and the fan are working normally, etc.